Flow patterns in gas-assisted injection molding process in a channel

Author： Hsu Cheng-Hsing Chen Po-Chuang Kung Kuang-Yuan Lai Chuan

ISSN： 0268-3768

Source： The International Journal of Advanced Manufacturing Technology, Vol.31, Iss.7-8, 2007-01, pp. : 673-681

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Computing gas/melt free interface of gas-assisted injection molding

By Chen Wei Zhou Xiong Han Xian

The International Journal of Advanced Manufacturing Technology, Vol. 52, Iss. 5-8, 2011-02 ,pp. : 521-529

Springer Publishing Company

Access to resources Recommend Favorite

Predicting the Method of Oil Recovery in the Gas-assisted Gravity Drainage Process

By Wu K. Li X. Wang X. Yan B. Ren M.

Petroleum Science and Technology, Vol. 31, Iss. 23, 2013-12 ,pp. : 2527-2533

Taylor & Francis Ltd

Access to resources Recommend Favorite

The selection of the optimal design parameters applied to the gas-assisted injection mould of an L-shape plates design

By Lee K.

The International Journal of Advanced Manufacturing Technology, Vol. 30, Iss. 7-8, 2006-10 ,pp. : 677-686

Springer Publishing Company

Access to resources Recommend Favorite

Flow instability of semicrystalline polymer melt during micro-injection molding

By Kim Dae-Jin Cho Younghak

Journal of Micromechanics and Microengineering, Vol. 24, Iss. 8, 2014-08 ,pp. : 85015-85031

IOP Publishing

Access to resources Recommend Favorite

Obtaining of Biopolymer from Onion Used as a Binder in Powder Injection Molding Process

Advanced Engineering Forum, Vol. 2018, Iss. 27, 2018-06 ,pp. : 50-55

Trans Tech Publications

Access to resources Recommend Favorite