Warpage phenomenon of thin-wall injection molding

Author： Chiang Yuh-Chyun   Cheng Hsin-Chung   Huang Chiung-Fang   Lee Jeou-Long   Lin Yi   Shen Yung-Kang  

Publisher： Springer Publishing Company

ISSN： 0268-3768

Source： The International Journal of Advanced Manufacturing Technology, Vol.55, Iss.5-8, 2011-07, pp. : 517-526

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Surface microstructure replication in injection molding

By Theilade Uffe   Hansen Hans  

The International Journal of Advanced Manufacturing Technology, Vol. 33, Iss. 1-2, 2007-05 ,pp. : 157-166

Springer Publishing Company

Access to resources Recommend Favorite

Crushing behavior of metallic thin-wall tubes with triggering mechanisms due to quasi-static axial compression

By Chiu Yuen-Sheng   Jenq Syh-Tsang  

Journal of the Chinese Institute of Engineers, Vol. 37, Iss. 4, 2014-05 ,pp. : 469-478

Taylor & Francis Ltd

Access to resources Recommend Favorite

The influence of cavity deformation on the shrinkage and warpage of an injection-molded part

By Wu Cheng-Hsien   Huang Yu-Jen  

The International Journal of Advanced Manufacturing Technology, Vol. 32, Iss. 11-12, 2007-05 ,pp. : 1144-1154

Springer Publishing Company

Access to resources Recommend Favorite

Powder injection molding 440C stainless steel

By Li Duxin   Hou Haitao   Liang Lianghua   Lee Kun  

The International Journal of Advanced Manufacturing Technology, Vol. 49, Iss. 1-4, 2010-07 ,pp. : 105-110

Springer Publishing Company

Access to resources Recommend Favorite

Microceramic injection molding of a multilayer micropatterned micropart

By Wang Min-Wen  

The International Journal of Advanced Manufacturing Technology, Vol. 51, Iss. 1-4, 2010-11 ,pp. : 145-153

Springer Publishing Company

Access to resources Recommend Favorite