Microceramic injection molding of a multilayer micropatterned micropart

Author： Wang Min-Wen  

Publisher： Springer Publishing Company

ISSN： 0268-3768

Source： The International Journal of Advanced Manufacturing Technology, Vol.51, Iss.1-4, 2010-11, pp. : 145-153

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Surface microstructure replication in injection molding

By Theilade Uffe   Hansen Hans  

The International Journal of Advanced Manufacturing Technology, Vol. 33, Iss. 1-2, 2007-05 ,pp. : 157-166

Springer Publishing Company

Access to resources Recommend Favorite

Powder injection molding 440C stainless steel

By Li Duxin   Hou Haitao   Liang Lianghua   Lee Kun  

The International Journal of Advanced Manufacturing Technology, Vol. 49, Iss. 1-4, 2010-07 ,pp. : 105-110

Springer Publishing Company

Access to resources Recommend Favorite

Warpage phenomenon of thin-wall injection molding

By Chiang Yuh-Chyun   Cheng Hsin-Chung   Huang Chiung-Fang   Lee Jeou-Long   Lin Yi   Shen Yung-Kang  

The International Journal of Advanced Manufacturing Technology, Vol. 55, Iss. 5-8, 2011-07 ,pp. : 517-526

Springer Publishing Company

Access to resources Recommend Favorite

Simulation of injection molding into rapid-prototyped molds

By Aluru Rajitha   Keefe Michael   Advani Suresh  

Rapid Prototyping Journal, Vol. 7, Iss. 1, 2001-03 ,pp. : 42-51

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Release behavior for powder injection molding in stereolithography molds

By Hemrick James G   Starr Thomas L   Rosen David W  

Rapid Prototyping Journal, Vol. 7, Iss. 2, 2001-04 ,pp. : 115-121

Emerald Group Publishing Ltd

Access to resources Recommend Favorite