Process‐induced phase and crystal morphologies in water‐assisted injection molded polypropylene/polymeric β‐nucleating agent blend parts

Publisher： John Wiley & Sons Inc

E-ISSN： 1548-2634|55|7|1698-1705

ISSN： 0032-3888

Source： POLYMER ENGINEERING & SCIENCE, Vol.55, Iss.7, 2015-07, pp. : 1698-1705

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Influence of different β‐nucleating agent on crystallization behavior, morphology, and melting characteristic of multiwalled carbon nanotube‐filled isotactic polypropylene nanocomposites

By  

POLYMER COMPOSITES, Vol. 36, Iss. 4, 2015-04 ,pp. : 635-643

John Wiley & Sons Inc

Access to resources Recommend Favorite

Novel foaming method to fabricate microcellular injection molded polycarbonate parts using sodium chloride and active carbon as nucleating agents

By  

POLYMER ENGINEERING & SCIENCE, Vol. 55, Iss. 7, 2015-07 ,pp. : 1634-1642

John Wiley & Sons Inc

Access to resources Recommend Favorite

Optimization and numerical simulation analysis for molded thin‐walled parts fabricated using wood‐filled polypropylene composites via plastic injection molding

By  

POLYMER ENGINEERING & SCIENCE, Vol. 55, Iss. 5, 2015-05 ,pp. : 1082-1095

John Wiley & Sons Inc

Access to resources Recommend Favorite

Flowing simulation of injection molded parts with micro-channel

By Cui Zhi-xiang   Si Jun-hui   Liu Chun-tai   Shen Chang-yu  

Applied Mathematics and Mechanics, Vol. 35, Iss. 3, 2014-03 ,pp. : 269-276

Springer Publishing Company

Access to resources Recommend Favorite

A novel silica‐based nucleating agent for polypropylene: Preparation, characterization, and application

By  

JOURNAL OF VINYL & ADDITIVE TECHNOLOGY, Vol. 24, Iss. 1, 2018-02 ,pp. : 58-67

John Wiley & Sons Inc

Access to resources Recommend Favorite