Comparative Assessment of Surface Roughness and Microstructure Produced in Whirlwind Milling of Bearing Steel

Author： Guo Qin   Ye Lin   Wang Yulin   Feng Hutian   Li Ying  

Publisher： Taylor & Francis Ltd

ISSN： 1091-0344

Source： Machining Science and Technology, Vol.18, Iss.2, 2014-04, pp. : 251-276

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Optimization and Prediction of Cutting Force and Surface Roughness in End Milling Process of AISI 304 Stainless Steel

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 813, 2015-12 ,pp. : 362-367

Trans Tech Publications

Access to resources Recommend Favorite

Analysis of Cutting Parameters Influence on the Machined Surface Roughness Obtained by Turning of a Heat Treated Bearing Steel

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 809, 2015-12 ,pp. : 195-200

Trans Tech Publications

Access to resources Recommend Favorite

A Prediction Model of Surface Roughness in Micro End Milling

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 727, 2015-03 ,pp. : 354-357

Trans Tech Publications

Access to resources Recommend Favorite

An Initial Study of the Effect of Minimum Quantity Lubricant of SiO2 Nanoparticle with PEG on Surface Roughness during Milling of Mild Steel

By  

Applied Mechanics and Materials, Vol. 2014, Iss. 695, 2015-01 ,pp. : 627-630

Trans Tech Publications

Access to resources Recommend Favorite

Parameteric Optimization of Surface Roughness in End Milling of Aluminium Rock Dust Composite

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 813, 2015-12 ,pp. : 382-387

Trans Tech Publications

Access to resources Recommend Favorite