The Influence of Milling Conditions on the Ni₃Fe Alloyed Powder

E-ISSN： 2234-991x|2015|13|75-82

ISSN： 2234-9898

Source： Advanced Engineering Forum, Vol.2015, Iss.13, 2015-08, pp. : 75-82

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Nanocrystalline/Nanosized Fe₃O₄ Powder Obtained by Mechanosynthesis

Advanced Engineering Forum, Vol. 2015, Iss. 13, 2015-08 ,pp. : 9-14

Trans Tech Publications

Access to resources Recommend Favorite

Research of the Fe₂O₃ Powder Granulation Effect on BaFe₁₂O₁₉ Firing Temperature

Advanced Engineering Forum, Vol. 2015, Iss. 13, 2015-08 ,pp. : 29-36

Trans Tech Publications

Access to resources Recommend Favorite

Composite Compacts of Fe/Fe₃O₄ Type Obtained by Mechanical Milling-Sintering-Annealing Route

Advanced Engineering Forum, Vol. 2015, Iss. 13, 2015-08 ,pp. : 3-8

Trans Tech Publications

Access to resources Recommend Favorite

Structural and Morphological Evaluation of 25% vol. Ni/Al₂O₃ Nanocomposite Powders Produced by Mechanical Milling

Advanced Engineering Forum, Vol. 2015, Iss. 13, 2015-08 ,pp. : 48-53

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Relative Density and Strain Rate on the Deformation Behaviour Ni-Ti Foam Made through Powder Metallurgy Route Using NH₄(HCO₃) as Space Holder

Advanced Engineering Forum, Vol. 2016, Iss. 15, 2016-03 ,pp. : 35-55

Trans Tech Publications

Access to resources Recommend Favorite