Composite Compacts of Fe/Fe₃O₄ Type Obtained by Mechanical Milling-Sintering-Annealing Route

E-ISSN： 2234-991x|2015|13|3-8

ISSN： 2234-9898

Source： Advanced Engineering Forum, Vol.2015, Iss.13, 2015-08, pp. : 3-8

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Nanocrystalline/Nanosized Fe₃O₄ Powder Obtained by Mechanosynthesis

Advanced Engineering Forum, Vol. 2015, Iss. 13, 2015-08 ,pp. : 9-14

Trans Tech Publications

Access to resources Recommend Favorite

Research of the Fe₂O₃ Powder Granulation Effect on BaFe₁₂O₁₉ Firing Temperature

Advanced Engineering Forum, Vol. 2015, Iss. 13, 2015-08 ,pp. : 29-36

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Nickel Addition Study on the Mechanical Properties of the (Fe₃C-Ni) Alloy Obtained by Solid Phase Compaction and Sintering

International Journal of Engineering Research in Africa, Vol. 2017, Iss. 32, 2017-10 ,pp. : 18-24

Trans Tech Publications

Access to resources Recommend Favorite

The Influence of Milling Conditions on the Ni₃Fe Alloyed Powder

Advanced Engineering Forum, Vol. 2015, Iss. 13, 2015-08 ,pp. : 75-82

Trans Tech Publications

Access to resources Recommend Favorite

Synthesis of Fe₇₅Si_20-xB₅M_x (M=Ti, Ta or Zr) Powders by Wet Mechanical Milling

Advanced Engineering Forum, Vol. 2015, Iss. 13, 2015-08 ,pp. : 54-58

Trans Tech Publications

Access to resources Recommend Favorite