Simulation of Cylinder Deformations during Honing of Thermally Coated Running Surfaces in Crankcases

E-ISSN： 1662-7482|2015|794|247-254

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.794, 2015-11, pp. : 247-254

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Nanoscale Evolution of Sliding Metal Surfaces During Running-in

By Dienwiebel Martin Pöhlmann Klaus

Tribology Letters, Vol. 27, Iss. 3, 2007-09 ,pp. : 255-260

Springer Publishing Company

Access to resources Recommend Favorite

Roughness of the Revolution Surfaces Processed by Honing

Applied Mechanics and Materials, Vol. 2015, Iss. 760, 2015-06 ,pp. : 483-488

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Initial Cylinder Liner Honing Surface Roughness on Aircraft Piston Engine Performances

By Woś Paweł

Tribology Letters, Vol. 41, Iss. 3, 2011-03 ,pp. : 555-567

Springer Publishing Company

Access to resources Recommend Favorite

Experimental Investigation of Local Temperature Increase in Disk Surfaces of Hard Disk Drives Due to Laser Heating During Thermally Assisted Magnetic Recording

By Tagawa Norio

Tribology Letters, Vol. 44, Iss. 1, 2011-10 ,pp. : 81-87

Springer Publishing Company

Access to resources Recommend Favorite

Kinematics of Foot during Running: A Review

Applied Mechanics and Materials, Vol. 2015, Iss. 786, 2015-09 ,pp. : 388-392

Trans Tech Publications

Access to resources Recommend Favorite