Comparison of Optimum Cutting Parameters for AISI1042 in Turning Operation by Genetic Algorithm and Particle Swarm Optimization

Publisher： Trans Tech Publications

E-ISSN： 1662-7482|2015|813|285-292

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.813, 2015-12, pp. : 285-292

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Optimization of Cutting Parameters during Turning of AISI-310 Using Response Surface Methodology

By  

Applied Mechanics and Materials, Vol. 2016, Iss. 854, 2017-02 ,pp. : 45-51

Trans Tech Publications

Access to resources Recommend Favorite

Self-Adaptive Particle Swarm Mutation Rate of Genetic Algorithm in the Link Optimization of Network Coding

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 713, 2015-02 ,pp. : 2478-2481

Trans Tech Publications

Access to resources Recommend Favorite

Parallel Optimum Design of Foil Bearing Using Particle Swarm Optimization Method

By Wang Nenzi  

Tribology Transactions, Vol. 56, Iss. 3, 2013-05 ,pp. : 453-460

Taylor & Francis Ltd

Access to resources Recommend Favorite

MACHINING PARAMETERS OPTIMIZATION FOR ALUMINA BASED CERAMIC CUTTING TOOLS USING GENETIC ALGORITHM

By Kumar A. Senthil  

Machining Science and Technology, Vol. 10, Iss. 4, 2006-10 ,pp. : 471-489

Taylor & Francis Ltd

Access to resources Recommend Favorite

Optimization of Cutting Parameters in Machining GFRP Using End Mill Cutter through DoE and Verification through Genetic Algorithm

By  

Applied Mechanics and Materials, Vol. 2017, Iss. 867, 2017-08 ,pp. : 134-147

Trans Tech Publications

Access to resources Recommend Favorite