Optimization of Cutting Parameters during Turning of AISI-310 Using Response Surface Methodology

Publisher： Trans Tech Publications

E-ISSN： 1662-7482|2016|854|45-51

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2016, Iss.854, 2017-02, pp. : 45-51

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Experimental Investigation of Machining Parameters during Turning of AISI 316L Stainless Steel Using Nano Cutting Environment

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 787, 2015-09 ,pp. : 361-365

Trans Tech Publications

Access to resources Recommend Favorite

Multi-Response Optimisation of Cutting Parameters of Wire EDM in Titanium Using Response Surface Methodology

By  

Applied Mechanics and Materials, Vol. 2016, Iss. 854, 2017-02 ,pp. : 93-100

Trans Tech Publications

Access to resources Recommend Favorite

Comparison of Optimum Cutting Parameters for AISI1042 in Turning Operation by Genetic Algorithm and Particle Swarm Optimization

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 813, 2015-12 ,pp. : 285-292

Trans Tech Publications

Access to resources Recommend Favorite

Evaluation of the Effects of Copper Electroplating Parameters on the Adhesion Using Response Surface Methodology

By  

Applied Mechanics and Materials, Vol. 2017, Iss. 864, 2017-05 ,pp. : 121-126

Trans Tech Publications

Access to resources Recommend Favorite

Process Optimization of Electric Discharge Machining Using Response Surface Methodology

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 813, 2015-12 ,pp. : 393-397

Trans Tech Publications

Access to resources Recommend Favorite