Studies on the Determination of Cutting Regime Optimal Parameters for Drilling Operation – Comparative Analysis between the Results Obtained by Using Analytical Method and Automated Method of Calculation

Publisher： Trans Tech Publications

E-ISSN： 1662-7482|2015|809|117-122

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.809, 2015-12, pp. : 117-122

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Results Obtained by the Cre Updating Method using a Plate Model

By Deraemaeker A.   LADEVÈZE P.   Le Loch S.  

Mechanical Systems and Signal Processing, Vol. 17, Iss. 1, 2003-01 ,pp. : 47-54

Academic Press

Access to resources Recommend Favorite

Analysis of Technique-Economy Studies of Branch System Calculation Method

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 733, 2015-04 ,pp. : 978-981

Trans Tech Publications

Access to resources Recommend Favorite

Comparative Investigation of an Automated Oceanic Wave Surface Glider Robot Influence on Resistance Prediction Using CFD Method

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 710, 2015-02 ,pp. : 91-97

Trans Tech Publications

Access to resources Recommend Favorite

Application of the Method Based on Knowledge and Experience for Adding the Cutting Tools and Parameters Selection

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 809, 2015-12 ,pp. : 1243-1248

Trans Tech Publications

Access to resources Recommend Favorite

Measuring Device for the Cutting Parameters Monitoring during Drilling

By  

Applied Mechanics and Materials, Vol. 2016, Iss. 827, 2016-03 ,pp. : 15-18

Trans Tech Publications

Access to resources Recommend Favorite