Measuring Device for the Cutting Parameters Monitoring during Drilling

Publisher： Trans Tech Publications

E-ISSN： 1662-7482|2016|827|15-18

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2016, Iss.827, 2016-03, pp. : 15-18

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Studies on the Determination of Cutting Regime Optimal Parameters for Drilling Operation – Comparative Analysis between the Results Obtained by Using Analytical Method and Automated Method of Calculation

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 809, 2015-12 ,pp. : 117-122

Trans Tech Publications

Access to resources Recommend Favorite

The Depth of Cut in Drilling Mode of Rock Cutting

By  

Applied Mechanics and Materials, Vol. 2017, Iss. 873, 2017-12 ,pp. : 292-297

Trans Tech Publications

Access to resources Recommend Favorite

Experimental Investigation of Machining Parameters during Turning of AISI 316L Stainless Steel Using Nano Cutting Environment

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 787, 2015-09 ,pp. : 361-365

Trans Tech Publications

Access to resources Recommend Favorite

Optimization of Cutting Parameters during Turning of AISI-310 Using Response Surface Methodology

By  

Applied Mechanics and Materials, Vol. 2016, Iss. 854, 2017-02 ,pp. : 45-51

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Cutting Parameters on Cutting Forces for Different Profile of Cutting

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 799, 2015-11 ,pp. : 361-365

Trans Tech Publications

Access to resources Recommend Favorite