Experimental Research of Effective Cutting Speed Influence on Surface Roughness in Ball End Milling of C45 Material with Hardness 54 HRC

Publisher： Trans Tech Publications

E-ISSN： 1662-7482|2015|809|27-32

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.809, 2015-12, pp. : 27-32

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Monitoring of Surface Roughness Based on Cutting Force and Cutting Temperature in Ball-End Milling Process by Utilizing Response Surface Analysis

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 799, 2015-11 ,pp. : 324-328

Trans Tech Publications

Access to resources Recommend Favorite

Investigating the Effect of Cutting Speed Variation on Surface Roughness of 7136 Aluminum Alloy in End Milling

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 809, 2015-12 ,pp. : 129-134

Trans Tech Publications

Access to resources Recommend Favorite

Experimental Analysis and Forecasting of Material Removal Rate and Cutting Force in End Milling on A356 Alloy-SiC Metal Matrix Composites

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 787, 2015-09 ,pp. : 637-642

Trans Tech Publications

Access to resources Recommend Favorite

Optimization and Prediction of Cutting Force and Surface Roughness in End Milling Process of AISI 304 Stainless Steel

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 813, 2015-12 ,pp. : 362-367

Trans Tech Publications

Access to resources Recommend Favorite

A Prediction Model of Surface Roughness in Micro End Milling

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 727, 2015-03 ,pp. : 354-357

Trans Tech Publications

Access to resources Recommend Favorite