Effect of Cutting Force Control on Cutting Characteristics of CFRP in Diamond Saw Cutting

E-ISSN： 1662-9795|2015|656|214-219

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.656, 2015-08, pp. : 214-219

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

A Study of Cutting Force and Force Coefficients in Orthogonal Cutting of High-Strength CFRP T700 Laminates

Key Engineering Materials, Vol. 2016, Iss. 693, 2016-06 ,pp. : 704-709

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Cutting Feed and Chip Size Ratio on Cutting Force

Solid State Phenomena, Vol. 2017, Iss. 261, 2017-09 ,pp. : 3-8

Trans Tech Publications

Access to resources Recommend Favorite

Optimization Design of Diamond Circular Saw-Blade with Discontinuous Cutting and Uneven Distribution for Cutting Thin-Walled Tubes

Key Engineering Materials, Vol. 2015, Iss. 667, 2016-02 ,pp. : 114-118

Trans Tech Publications

Access to resources Recommend Favorite

Study on the Cutting Characteristics of Drilling CFRP Using Exterior Materials of Automobile

Key Engineering Materials, Vol. 2017, Iss. 730, 2017-03 ,pp. : 295-300

Trans Tech Publications

Access to resources Recommend Favorite

Characteristics of Short Cast Iron Fibres and Their Application for Diamond Cutting Wheels

By Li D. Tian Y. Cai B. Chen B.

Powder Metallurgy, Vol. 38, Iss. 2, 1995-01 ,pp. : 109-112

Maney Publishing

Access to resources Recommend Favorite