Optimization Design of Diamond Circular Saw-Blade with Discontinuous Cutting and Uneven Distribution for Cutting Thin-Walled Tubes

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2015|667|114-118

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.667, 2016-02, pp. : 114-118

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effect of Cutting Force Control on Cutting Characteristics of CFRP in Diamond Saw Cutting

By  

Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. : 214-219

Trans Tech Publications

Access to resources Recommend Favorite

Study and Build-Up of Deformation Zone at Cutting of Thin-Walled Tube by Torsion

By  

Key Engineering Materials, Vol. 2017, Iss. 746, 2017-08 ,pp. : 16-21

Trans Tech Publications

Access to resources Recommend Favorite

Study of Electroplated Nickel Layer Thickness and Saw Parameters on Cutting Performance in Diamond Wire Sawing of Sapphire Ingots

By  

Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. : 450-455

Trans Tech Publications

Access to resources Recommend Favorite

Stress Analysis of the Rotating Circular Saw Blade

By  

Solid State Phenomena, Vol. 2017, Iss. 261, 2017-09 ,pp. : 259-266

Trans Tech Publications

Access to resources Recommend Favorite

Thin-walled composite tubes using fillers subjected to quasistatic axial compression

By  

IOP Conference Series: Materials Science and Engineering, Vol. 78, Iss. 1, 2015-04 ,pp. : 201-212

IOP Publishing

Access to resources Recommend Favorite