Effects of Supplying Oil Mist and Water Mist with Cold Air on Cutting Force and Temperature in End Milling of Difficult-to-Cut Materials

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2015|656|255-260

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.656, 2015-08, pp. : 255-260

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Investigation of Machinability in Milling of Difficult-to-Cut Materials Using Water Soluble and Water Insoluble Cutting Oil

By  

Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. : 308-313

Trans Tech Publications

Access to resources Recommend Favorite

Research on the Influence of Tool Wear on Cutting Performance in High-Speed Milling of Difficult-to-Cut Materials

By  

Key Engineering Materials, Vol. 2016, Iss. 693, 2016-06 ,pp. : 1129-1134

Trans Tech Publications

Access to resources Recommend Favorite

Machinability Evaluation of Inclined Planetary Motion Milling System for Difficult-to-Cut Materials

By  

Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. : 320-327

Trans Tech Publications

Access to resources Recommend Favorite

Application of Taguchi Method to Optimization of Cutting Force and Temperature during Turning of Difficult to Cut Materials

By  

Key Engineering Materials, Vol. 2016, Iss. 686, 2016-03 ,pp. : 114-118

Trans Tech Publications

Access to resources Recommend Favorite

Wear of PCBN Tool when Cutting Materials Difficult-to-Cut Based on Thermodynamics Solubility

By  

Key Engineering Materials, Vol. 2016, Iss. 693, 2016-06 ,pp. : 1207-1215

Trans Tech Publications

Access to resources Recommend Favorite