Dynamic Recrystallization Observed at the Tool/Chip Interface in Machining

E-ISSN： 1662-9795|2015|651|1223-1228

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.651, 2015-08, pp. : 1223-1228

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Experimental and Simulation Study on Friction Condition of the Tool-Chip Interface during Cutting Process

Key Engineering Materials, Vol. 2016, Iss. 693, 2016-06 ,pp. : 747-754

Trans Tech Publications

Access to resources Recommend Favorite

Effect of High-Pressure Coolant Supply on Chip-Breaking and Tool Wear in Machining of Stainless Steel

Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. : 226-230

Trans Tech Publications

Access to resources Recommend Favorite

The influence of austenite grain size and its distribution on chip deformation and tool life during machining of AISI 304L

By Jiang Laizhu Roos Åke Liu Ping

Metallurgical and Materials Transactions A, Vol. 28, Iss. 11, 1997-11 ,pp. : 2415-2422

Springer Publishing Company

Access to resources Recommend Favorite

Investigation of Chip Dimensional Characteristics Created by the Specific Cutting Tool at the Machining of 12 050 Steel

Key Engineering Materials, Vol. 2017, Iss. 730, 2017-03 ,pp. : 301-305

Trans Tech Publications

Access to resources Recommend Favorite

Dynamic Recrystallization in Titanium Alloys

Key Engineering Materials, Vol. 2016, Iss. 687, 2016-05 ,pp. : 47-54

Trans Tech Publications

Access to resources Recommend Favorite