Investigation of Chip Dimensional Characteristics Created by the Specific Cutting Tool at the Machining of 12 050 Steel

E-ISSN： 1662-9795|2017|730|301-305

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2017, Iss.730, 2017-03, pp. : 301-305

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Performance characteristics of ceria toughened alumina ceramic cutting tool on machining C30 steel

By Senthil Kumar A. Raja Durai A. Sornakumar T.

Powder Metallurgy, Vol. 47, Iss. 3, 2004-09 ,pp. : 235-238

Maney Publishing

Access to resources Recommend Favorite

Impact of Cutting Speed on the Resultant Durability of Cutting Tool in Machining Process of Steel C45

Key Engineering Materials, Vol. 2015, Iss. 669, 2016-02 ,pp. : 294-301

Trans Tech Publications

Access to resources Recommend Favorite

An investigation of cutting mechanics in 2 dimensional ultrasonic vibration assisted milling toward chip thickness and chip formation

IOP Conference Series: Materials Science and Engineering, Vol. 100, Iss. 1, 2015-12 ,pp. : 468-473

IOP Publishing

Access to resources Recommend Favorite

Effect of High-Pressure Coolant Supply on Chip-Breaking and Tool Wear in Machining of Stainless Steel

Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. : 226-230

Trans Tech Publications

Access to resources Recommend Favorite

Dynamic Recrystallization Observed at the Tool/Chip Interface in Machining

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 1223-1228

Trans Tech Publications

Access to resources Recommend Favorite