Formability of High Strength Sheet Metals with Special Regard to the Effect of the Influential Factors on the Forming Limit Diagrams

Publisher： Trans Tech Publications

E-ISSN： 1662-9752|2015|812|271-275

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2015, Iss.812, 2015-03, pp. : 271-275

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effect of Bending Strain in Forming Limit Strain and Stress of IN-718 Sheet Metal

By  

Materials Science Forum, Vol. 2015, Iss. 830, 2015-10 ,pp. : 238-241

Trans Tech Publications

Access to resources Recommend Favorite

Methods for Obtaining Forming Limit Diagrams of Material Defects

By  

Materials Science Forum, Vol. 2016, Iss. 878, 2017-01 ,pp. : 8-12

Trans Tech Publications

Access to resources Recommend Favorite

Predicting springback in sheet metal forming: an explicit to implicit sequential solution procedure - a process to reduce sidewall curl springback in high-strength steel rails

By Narasimhan N.   Lovell M.  

Finite Elements in Analysis and Design, Vol. 33, Iss. 1, 1999-08 ,pp. : 29-42

Elsevier

Access to resources Recommend Favorite

Effect of Ultra-Fast Cooling Rate on the Microstructure and Mechanical Properties of High Strength Cold-Rolled Sheet under Continuous Annealing

By  

Materials Science Forum, Vol. 2018, Iss. 913, 2018-03 ,pp. : 311-316

Trans Tech Publications

Access to resources Recommend Favorite

Numerical Simulation of the Forming Limit of Superplastic AZ31B Magnesium Alloy Sheet

By  

Materials Science Forum, Vol. 2017, Iss. 898, 2017-07 ,pp. : 159-167

Trans Tech Publications

Access to resources Recommend Favorite