Modeling of Flow Stress and Grain Size Based on Z Parameter and Material Constants of Al-5.2Mg-0.6Mn Alloy during Hot Deformation

Publisher： Trans Tech Publications

E-ISSN： 1662-9752|2015|817|748-754

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2015, Iss.817, 2015-05, pp. : 748-754

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The Portevin-Le Chatelier Effect and Kinematics of Deformation Bands in an Al-Mg-Sc Alloy: Effect of Grain Size

By  

Materials Science Forum, Vol. 2016, Iss. 879, 2017-02 ,pp. : 2268-2273

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Initial Microstructure on the Hot Working Flow Stress of Mg-3Al-1Zn Alloy

By  

Materials Science Forum, Vol. 2017, Iss. 898, 2017-07 ,pp. : 86-90

Trans Tech Publications

Access to resources Recommend Favorite

Grain Growth Behavior of AlMg5 Alloy Fabricated by Using a New Mg Mother Alloy Containing Al2Ca during Homogenization and Hot Compression

By  

Materials Science Forum, Vol. 2016, Iss. 877, 2017-01 ,pp. : 328-333

Trans Tech Publications

Access to resources Recommend Favorite

Hot Deformation Behavior of Al-Cu-Li-Mg-Zn-Zr-Sc Alloy in As-Cast and Hot-Rolled Condition

By  

Materials Science Forum, Vol. 2018, Iss. 920, 2018-05 ,pp. : 244-249

Trans Tech Publications

Access to resources Recommend Favorite

Mechanical Behavior of an Al–Mg–Mn–Sc Alloy with an Ultrafine Grain Structure at Cryogenic Temperatures

By  

ADVANCED ENGINEERING MATERIALS (ELECTRONIC), Vol. 17, Iss. 12, 2015-12 ,pp. : 1804-1811

John Wiley & Sons Inc

Access to resources Recommend Favorite