Application of 3D Сomputed Microtomography for Investigating the Microstructural Defects of Carbon Fiber Reinforced Composite Made by 3D-Printing

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2016|712|324-327

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2016, Iss.712, 2016-10, pp. : 324-327

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Applying 3D-printing technology in planning operations of cancer patients

By  

IOP Conference Series: Materials Science and Engineering, Vol. 69, Iss. 1, 2014-12 ,pp. : 70-73

IOP Publishing

Access to resources Recommend Favorite

Increasing Fracture Toughness for 3D Multiscale Carbon Nanotube and Carbon Fiber Reinforced Composites

By  

Key Engineering Materials, Vol. 2016, Iss. 713, 2016-11 ,pp. : 131-134

Trans Tech Publications

Access to resources Recommend Favorite

Heat Transfer and Phase Formation through EBM 3D-Printing of Ti-6Al-4V Cylindrical Parts

By  

Defect and Diffusion Forum, Vol. 2018, Iss. 383, 2018-03 ,pp. : 190-195

Trans Tech Publications

Access to resources Recommend Favorite

Preparation of Camphene Carbon/Silicon Carbide Slurry for 3D Printing

By  

Key Engineering Materials, Vol. 2016, Iss. 697, 2016-08 ,pp. : 159-162

Trans Tech Publications

Access to resources Recommend Favorite

The 3-D Analysis of Discontinuously Reinforced Aluminum Composite Microstructures

By Spowart Jonathan E.  

JOM, Vol. 58, Iss. 12, 2006-12 ,pp. : 29-33

Springer Publishing Company

Access to resources Recommend Favorite