Publisher： Edp Sciences
E-ISSN： 2257-7750|16|7|702-702
ISSN： 2257-7777
Source： Mechanics & Industry, Vol.16, Iss.7, 2015-11, pp. : 702-702
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
Related content
An investigation on the cutting force of milling Inconel 718
MATEC Web of conference, Vol. 169, Iss. issue, 2018-05 ,pp. :
Access to resources
Recommend
Influence of the cutting parameters on the workpiece temperature during face milling
EPJ Web of Conference, Vol. 143, Iss. issue, 2017-05 ,pp. :
By Fnides B. Aouici H. Elbah M. Boutabba S. Boulanouar L.
Mechanics & Industry, Vol. 16, Iss. 6, 2015-09 ,pp. :
Access to resources
The investigation of the chip behaviour during the end milling cutting process
MATEC Web of conference, Vol. 112, Iss. issue, 2017-07 ,pp. :
Evaluation of cutting force and surface roughness in high-speed milling of compacted graphite iron
MATEC Web of conference, Vol. 101, Iss. issue, 2017-03 ,pp. :