Evaluation of cutting force and surface roughness in high-speed milling of compacted graphite iron

E-ISSN： 2261-236x|101|issue|03016-03016

ISSN： 2261-236x

Source： MATEC Web of conference, Vol.101, Iss.issue, 2017-03, pp. : 03016-03016

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

An Experiment Study on Surface Roughness in High Speed Milling NAK80 Die Steel

MATEC Web of conference, Vol. 75, Iss. issue, 2016-09 ,pp. : 02002-02002

Edp Sciences

Access to resources Recommend Favorite

Noise Reduction Processes in Cutting with High-Speed Tools

By Toenshoff H. K. Scherger A. Westphal R.

Noise Control Engineering, Vol. 17, Iss. 3, 1981-11 ,pp. : 126-131

Institute of Noise Control Engineering

Access to resources Recommend Favorite

Prediction of surface roughness and cutting force under MQL turning of AISI 4340 with nano fluid by using response surface methodology

By Patole Pralhad B. Kulkarni Vivek V.

Manufacturing Review, Vol. 5, Iss. issue, 2018-06 ,pp. : 5-5

Edp Sciences

Access to resources Recommend Favorite

Study of Cutting Edge Temperature and Cutting Force of End Mill Tool in High Speed Machining

MATEC Web of conference, Vol. 87, Iss. issue, 2017-08 ,pp. : 02030-02030

Edp Sciences

Access to resources Recommend Favorite

An investigation on the cutting force of milling Inconel 718

By Tsai Jhy-Cherng

MATEC Web of conference, Vol. 169, Iss. issue, 2018-05 ,pp. : 01039-01039

Edp Sciences

Access to resources Recommend Favorite