Dimensional optimization of the Stewart platform based on inertia decoupling characteristic

E-ISSN： 1469-8668|34|5|1151-1167

ISSN： 0263-5747

Source： Robotica, Vol.34, Iss.5, 2016-05, pp. : 1151-1167

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Inertia strongly influences the dynamic performance of parallel manipulators, and ignorance of inertia is apt to result in negative phenomena such as vibrations, overshoot, and slow response. This study analyzes the inertia-decoupling characteristic of Stewart platform. Because the inertia matrix of the Stewart platform is usually non-diagonal, inertia coupling occurs between its legs. Herein, decoupling to inertia is implemented, and independent control channels are determined. The influence of decoupled inertia on the control system is analyzed using the Adams simulation software, and the inertia index of the Stewart platform is proposed. Experiments are conducted on a prototype of the Stewart platform to verify the eigenvalue characteristic of decoupled inertia. The distribution of inertia index in the operational workspace is provided, and the influence of dimensional parameters on inertia index is discussed. Finally, dimensional optimization is realized with a set of optimized dimensions for good dynamic performance.