![](/images/ico/ico_close.png)
![](/images/ico/ico5.png)
Publisher: Trans Tech Publications
E-ISSN: 1662-9795|2016|705|227-232
ISSN: 1013-9826
Source: Key Engineering Materials, Vol.2016, Iss.705, 2016-09, pp. : 227-232
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
Related content
![](/images/ico/ico_close.png)
![](/images/ico/ico5.png)
Study on the Cutting Characteristics of Drilling CFRP Using Exterior Materials of Automobile
Key Engineering Materials, Vol. 2017, Iss. 730, 2017-03 ,pp. :
![](/images/ico/ico_close.png)
![](/images/ico/ico5.png)
Effects of Tool-Edge Form during the Drilling of CFRP
Key Engineering Materials, Vol. 2017, Iss. 749, 2017-09 ,pp. :
![](/images/ico/ico_close.png)
![](/images/ico/ico5.png)
![](/images/ico/ico_close.png)
![](/images/ico/ico5.png)
Phase angle in indentation-induced delamination with buckling
By Huang B. Zhao M.-H. Gao C.-F. Zhang T.-Y.
Scripta Materialia, Vol. 50, Iss. 5, 2004-03 ,pp. :