Effects of Tool-Edge Form during the Drilling of CFRP

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2017|749|141-147

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2017, Iss.749, 2017-09, pp. : 141-147

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Wet Core Drilling of CFRP with an Electrodeposited Diamond Core Drill - Effects of Cutting Conditions on Chip Evacuation and Core Jamming

By  

Key Engineering Materials, Vol. 2017, Iss. 749, 2017-09 ,pp. : 58-64

Trans Tech Publications

Access to resources Recommend Favorite

Experimental Investigation of Bouncing-Back of Multidirectional CFRP Laminates during Ultrasonic Assisted Edge Trimming

By  

Defect and Diffusion Forum, Vol. 2018, Iss. 382, 2018-02 ,pp. : 109-113

Trans Tech Publications

Access to resources Recommend Favorite

Effects of Cutting Speed, Cutting Fluid, and Carbon Fiber Orientation on Cutting of CFRP during Turning

By  

Key Engineering Materials, Vol. 2017, Iss. 740, 2017-07 ,pp. : 133-138

Trans Tech Publications

Access to resources Recommend Favorite

Comparative Study of Drilling Induced Delamination in CFRP with Different Ply Orientation

By  

Key Engineering Materials, Vol. 2016, Iss. 705, 2016-09 ,pp. : 227-232

Trans Tech Publications

Access to resources Recommend Favorite

Study on the Cutting Characteristics of Drilling CFRP Using Exterior Materials of Automobile

By  

Key Engineering Materials, Vol. 2017, Iss. 730, 2017-03 ,pp. : 295-300

Trans Tech Publications

Access to resources Recommend Favorite