Multi-Response Optimisation of Cutting Parameters of Wire EDM in Titanium Using Response Surface Methodology

E-ISSN： 1662-7482|2016|854|93-100

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2016, Iss.854, 2017-02, pp. : 93-100

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Multi-Response Optimization of Wire-EDM Process Parameters of Titanium Alloy Using Taguchi Method and Grey Relational Analysis

Applied Mechanics and Materials, Vol. 2015, Iss. 772, 2015-08 ,pp. : 245-249

Trans Tech Publications

Access to resources Recommend Favorite

A Study on Influence of System Parameters on Servo Pneumatic System and Multi-Response Optimization Using Taguchi – Grey Methodology

Applied Mechanics and Materials, Vol. 2015, Iss. 789, 2015-10 ,pp. : 901-905

Trans Tech Publications

Access to resources Recommend Favorite

Optimization of Cutting Parameters during Turning of AISI-310 Using Response Surface Methodology

Applied Mechanics and Materials, Vol. 2016, Iss. 854, 2017-02 ,pp. : 45-51

Trans Tech Publications

Access to resources Recommend Favorite

Evaluation of the Effects of Copper Electroplating Parameters on the Adhesion Using Response Surface Methodology

Applied Mechanics and Materials, Vol. 2017, Iss. 864, 2017-05 ,pp. : 121-126

Trans Tech Publications

Access to resources Recommend Favorite

Process Optimization of Electric Discharge Machining Using Response Surface Methodology

Applied Mechanics and Materials, Vol. 2015, Iss. 813, 2015-12 ,pp. : 393-397

Trans Tech Publications

Access to resources Recommend Favorite