Intergranular Corrosion Mechanism of Brazed Al-Mn-Cu-Si Alloy

Publisher： Trans Tech Publications

E-ISSN： 1662-9752|2016|877|492-497

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.877, 2017-01, pp. : 492-497

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Influence of Precipitation Hardening on the Sliding Wear Behavior of a Cu-Zn-Al-Mn-Si Based Brass Alloy

By  

Materials Science Forum, Vol. 2017, Iss. 898, 2017-07 ,pp. : 355-360

Trans Tech Publications

Access to resources Recommend Favorite

Improvement of Microstructure and Mechanical Properties of Secondary AlSi8Cu2Mn Cast Alloy by Strontium

By  

Materials Science Forum, Vol. 2017, Iss. 891, 2017-04 ,pp. : 350-353

Trans Tech Publications

Access to resources Recommend Favorite

The Corrosion Characteristics of AlSi1MgMn

By  

Materials Science Forum, Vol. 2015, Iss. 818, 2015-06 ,pp. : 125-128

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Varying Process Parameters on the Microstructure and Mechanical Properties of Cu-Cr-Zr-Ti Alloy Brazed Using Cu-Mn-Ni-Sn-Fe Foil

By  

Materials Science Forum, Vol. 2015, Iss. 830, 2015-10 ,pp. : 253-256

Trans Tech Publications

Access to resources Recommend Favorite

The Effect of Mg Content on Intergranular Corrosion of Al-Mg-Mn Alloys after Annealing

By  

Materials Science Forum, Vol. 2016, Iss. 877, 2017-01 ,pp. : 514-521

Trans Tech Publications

Access to resources Recommend Favorite