Ti-Cu-Based Amorphous Powders Produced by Ball-Milling

E-ISSN： 1662-9752|2016|879|1974-1979

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.879, 2017-02, pp. : 1974-1979

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The Influence of Ball-milling on Structural and Magnetic Properties of Co-based Powders

By Degmova J. Toth I. Bednarcik J. Kollar P.

Czechoslovak Journal of Physics, Vol. 55, Iss. 7, 2005-07 ,pp. : 791-801

Springer Publishing Company

Access to resources Recommend Favorite

Structural Evaluation of Ti-Cr-Si-B Powders Produced by High-Energy Ball Milling and Sintering

Materials Science Forum, Vol. 2017, Iss. 899, 2017-08 ,pp. : 499-504

Trans Tech Publications

Access to resources Recommend Favorite

High-Energy Ball Milling and Subsequent Heat Treatment of Ti-Cu-Si-B Powders

Materials Science Forum, Vol. 2017, Iss. 899, 2017-08 ,pp. : 463-468

Trans Tech Publications

Access to resources Recommend Favorite

Formation of Al-Ti-B Phases for Grain Refinement of Al Alloys Produced by High Energy Ball Milling

Materials Science Forum, Vol. 2017, Iss. 907, 2017-10 ,pp. : 188-192

Trans Tech Publications

Access to resources Recommend Favorite

Effect of High Energy Ball Milling on Structures and Properties of Atomization Fe-Based Nanocrystalline Soft Magnetic Powders

Materials Science Forum, Vol. 2016, Iss. 849, 2016-04 ,pp. : 844-851

Trans Tech Publications

Access to resources Recommend Favorite