Structural Evaluation of Ti-Cr-Si-B Powders Produced by High-Energy Ball Milling and Sintering

E-ISSN： 1662-9752|2017|899|499-504

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2017, Iss.899, 2017-08, pp. : 499-504

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Structural and Microstructural Properties of Si-C and Si-C-B Powders Obtained by High-Energy Ball Milling

Materials Science Forum, Vol. 2016, Iss. 869, 2016-10 ,pp. : 19-24

Trans Tech Publications

Access to resources Recommend Favorite

High-Energy Ball Milling and Subsequent Heat Treatment of Ti-Cu-Si-B Powders

Materials Science Forum, Vol. 2017, Iss. 899, 2017-08 ,pp. : 463-468

Trans Tech Publications

Access to resources Recommend Favorite

Formation of Al-Ti-B Phases for Grain Refinement of Al Alloys Produced by High Energy Ball Milling

Materials Science Forum, Vol. 2017, Iss. 907, 2017-10 ,pp. : 188-192

Trans Tech Publications

Access to resources Recommend Favorite

Ti-Cu-Based Amorphous Powders Produced by Ball-Milling

Materials Science Forum, Vol. 2016, Iss. 879, 2017-02 ,pp. : 1974-1979

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Boron and Carbon Addition on the Phase Transformations during High-Energy Ball Milling and Subsequent Sintering of Si₃N₄+B and Si₃N₄+C Powder Mixtures

Materials Science Forum, Vol. 2016, Iss. 869, 2016-10 ,pp. : 58-63

Trans Tech Publications

Access to resources Recommend Favorite