Observation of Built-up Edge Formation on a Carbide Cutting Tool with Machining Aluminium Alloy under Dry and Wet Conditions

Publisher： Edp Sciences

E-ISSN： 2261-236x|97|issue|01076-01076

ISSN： 2261-236x

Source： MATEC Web of conference, Vol.97, Iss.issue, 2017-02, pp. : 01076-01076

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Study on Surface Integrity of AISI 1045 Carbon Steel when machined by Carbide Cutting Tool under wet conditions

By  

MATEC Web of conference, Vol. 97, Iss. issue, 2017-02 ,pp. : 01075-01075

Edp Sciences

Access to resources Recommend Favorite

Influence of the cutting edge microgeometry on the tool life in austenitic stainless steel machining with carbide end mill

By  

MATEC Web of conference, Vol. 112, Iss. issue, 2017-07 ,pp. : 01016-01016

Edp Sciences

Access to resources Recommend Favorite

The Influence of Tool Geometry towards Cutting Performance in Machining Aluminium 7075

By  

MATEC Web of conference, Vol. 97, Iss. issue, 2017-02 ,pp. : 01079-01079

Edp Sciences

Access to resources Recommend Favorite

The study of the process of chip segmentation in case of edge cutting machining of titanium alloy

By  

MATEC Web of conference, Vol. 129, Iss. issue, 2017-11 ,pp. : 01065-01065

Edp Sciences

Access to resources Recommend Favorite

Study of Cutting Edge Temperature and Cutting Force of End Mill Tool in High Speed Machining

By  

MATEC Web of conference, Vol. 87, Iss. issue, 2017-08 ,pp. : 02030-02030

Edp Sciences

Access to resources Recommend Favorite