Study of Cutting Edge Temperature and Cutting Force of End Mill Tool in High Speed Machining

Publisher： Edp Sciences

E-ISSN： 2261-236x|87|issue|02030-02030

ISSN： 2261-236x

Source： MATEC Web of conference, Vol.87, Iss.issue, 2017-08, pp. : 02030-02030

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Influence of the cutting edge microgeometry on the tool life in austenitic stainless steel machining with carbide end mill

By  

MATEC Web of conference, Vol. 112, Iss. issue, 2017-07 ,pp. : 01016-01016

Edp Sciences

Access to resources Recommend Favorite

The high-performance machining of the curved surfaces with the progressive cutting geometry of the end mill

By  

MATEC Web of conference, Vol. 129, Iss. issue, 2017-11 ,pp. : 01057-01057

Edp Sciences

Access to resources Recommend Favorite

Evaluation of cutting temperature of a tool with a curved cutting edge

By  

MATEC Web of conference, Vol. 132, Iss. issue, 2017-10 ,pp. : 01005-01005

Edp Sciences

Access to resources Recommend Favorite

The study of the process of chip segmentation in case of edge cutting machining of titanium alloy

By  

MATEC Web of conference, Vol. 129, Iss. issue, 2017-11 ,pp. : 01065-01065

Edp Sciences

Access to resources Recommend Favorite

Observation of Built-up Edge Formation on a Carbide Cutting Tool with Machining Aluminium Alloy under Dry and Wet Conditions

By  

MATEC Web of conference, Vol. 97, Iss. issue, 2017-02 ,pp. : 01076-01076

Edp Sciences

Access to resources Recommend Favorite