The Transverse Rupture Strength in Ti-6Al-4V Alloy Manufactured by Selective Laser Melting

Publisher： Edp Sciences

E-ISSN： 2261-236x|27|issue|02010-02010

ISSN： 2261-236x

Source： MATEC Web of conference, Vol.27, Iss.issue, 2015-10, pp. : 02010-02010

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Microstructure and micro-hardness analyses of titanium alloy Ti-6Al-4V parts manufactured by selective laser melting

By  

MATEC Web of conference, Vol. 94, Iss. issue, 2017-01 ,pp. : 03009-03009

Edp Sciences

Access to resources Recommend Favorite

Study of the impact of treatment modes on hardness, deformability and microstructure of VT6 (Ti-6Al-4V) and VV751P (Ni-15Co-10Cr) alloy samples after selective laser sintering

By  

MATEC Web of conference, Vol. 129, Iss. issue, 2017-11 ,pp. : 01055-01055

Edp Sciences

Access to resources Recommend Favorite

Influence of casting defects on fatigue strength of an investment cast Ti-6Al-4V alloy

By  

MATEC Web of conference, Vol. 12, Iss. issue, 2014-06 ,pp. : 04004-04004

Edp Sciences

Access to resources Recommend Favorite

Influence of as-built surface on fatigue strength and notch sensitivity of Ti6Al4V alloy produced by DMLS

By Nicoletto Gianni  

MATEC Web of conference, Vol. 165, Iss. issue, 2018-05 ,pp. : 02002-02002

Edp Sciences

Access to resources Recommend Favorite

Coating of Ti-6Al-4V alloy substrates with TiN/Ti multi-layered films by magnetron sputtering*

By Sonoda T.   Kotake S.   Katou K.   Asahina T.  

EPJ Applied Physics (The), Vol. 38, Iss. 1, 2007-03 ,pp. : 69-72

Edp Sciences

Access to resources Recommend Favorite