Comparative analysis of aluminium surface roughness in end-milling under dry and minimum quantity lubrication (MQL) conditions

Author： Okonkwo Ugochukwu C.   Okokpujie Imhade P.   Sinebe Jude E.   Ezugwu Chinedu A.K.  

Publisher： Edp Sciences

E-ISSN： 2265-4224|2|issue|30-30

ISSN： 2265-4224

Source： Manufacturing Review, Vol.2, Iss.issue, 2016-01, pp. : 30-30

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Optimization of the Surface Roughness Equation obtained by Al7136 End-Milling

By Pop Alina Bianca  

MATEC Web of conference, Vol. 137, Iss. issue, 2017-11 ,pp. : 03011-03011

Edp Sciences

Access to resources Recommend Favorite

Prediction of surface roughness and cutting force under MQL turning of AISI 4340 with nano fluid by using response surface methodology

By Patole Pralhad B.   Kulkarni Vivek V.  

Manufacturing Review, Vol. 5, Iss. issue, 2018-06 ,pp. : 5-5

Edp Sciences

Access to resources Recommend Favorite

Minimum Quantity Lubrication and Carbon Footprint: A Step towards Sustainability

By Omair Muhammad   Sarkar Biswajit   Cárdenas-Barrón Leopoldo Eduardo  

Sustainability, Vol. 9, Iss. 5, 2017-04 ,pp. : 714-714

MDPI

Access to resources Recommend Favorite

Wave attenuation effects on the chatter instability of end-milling

By Ozoegwu C.G.   Omenyi S.N.  

Noise Control Engineering Journal, Vol. 61, Iss. 4, 2013-07 ,pp. : 436-444

Institute of Noise Control Engineering

Access to resources Recommend Favorite

Observation of Built-up Edge Formation on a Carbide Cutting Tool with Machining Aluminium Alloy under Dry and Wet Conditions

By  

MATEC Web of conference, Vol. 97, Iss. issue, 2017-02 ,pp. : 01076-01076

Edp Sciences

Access to resources Recommend Favorite