Multi-response optimisation of machining parameters during drilling LM6Mg15SiC-Al-MMC based on Grey relational analysis

By Manna Alakesh  

International Journal of Machining and Machinability of Materials, Vol. 14, Iss. 3, 2013-09 ,pp. : 275-294

Inderscience Publishers

Access to resources Recommend Favorite

Influence of machining parameters on surface roughness in finish cut of WEDM

By Han Fuzhu   Jiang Jun   Yu Dingwen  

The International Journal of Advanced Manufacturing Technology, Vol. 34, Iss. 5-6, 2007-09 ,pp. : 538-546

Springer Publishing Company

Access to resources Recommend Favorite

The effect of machining parameters on surface roughness and material removal rate with cryogenic treated wire in WEDM

By Kapoor Jatinder   Khamba Jaimal Singh   Singh Sehijpal  

International Journal of Machining and Machinability of Materials, Vol. 12, Iss. 1-2, 2012-08 ,pp. : 126-141

Inderscience Publishers

Access to resources Recommend Favorite

Prediction of surface roughness during abrasive flow machining

By Gorana V.   Jain V.   Lal G.  

The International Journal of Advanced Manufacturing Technology, Vol. 31, Iss. 3-4, 2006-11 ,pp. : 258-267

Springer Publishing Company

Access to resources Recommend Favorite

Multi-Response Optimization of WEDM Process Using Hybrid Approach While Machining Inconel 625 Superalloy

By  

Journal of Machining and Forming Technologies, Vol. , Iss. , 2014-07 ,pp. : 7-16

Nova Science Publishers, Inc.

Access to resources Recommend Favorite