Analysis on the Factors of Surface Morphologies on Si₃N₄ Ceramic Internal Grinding

E-ISSN： 1663-4144|2017|31|44-52

ISSN： 1663-3571

Source： International Journal of Engineering Research in Africa, Vol.2017, Iss.31, 2017-08, pp. : 44-52

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Nanocrystalline/Nanosized Fe₃O₄ Powder Obtained by Mechanosynthesis

Advanced Engineering Forum, Vol. 2015, Iss. 13, 2015-08 ,pp. : 9-14

Trans Tech Publications

Access to resources Recommend Favorite

Composite Compacts of Fe/Fe₃O₄ Type Obtained by Mechanical Milling-Sintering-Annealing Route

Advanced Engineering Forum, Vol. 2015, Iss. 13, 2015-08 ,pp. : 3-8

Trans Tech Publications

Access to resources Recommend Favorite

Synthesis of Fe₇₅Si_20-xB₅M_x (M=Ti, Ta or Zr) Powders by Wet Mechanical Milling

Advanced Engineering Forum, Vol. 2015, Iss. 13, 2015-08 ,pp. : 54-58

Trans Tech Publications

Access to resources Recommend Favorite

Research of the Fe₂O₃ Powder Granulation Effect on BaFe₁₂O₁₉ Firing Temperature

Advanced Engineering Forum, Vol. 2015, Iss. 13, 2015-08 ,pp. : 29-36

Trans Tech Publications

Access to resources Recommend Favorite

Estimation of Mixed-Mode Stress Intensity Factors with Presence of the Confinement Parameters T-Stress and A₃

Advanced Engineering Forum, Vol. 2016, Iss. 18, 2016-10 ,pp. : 52-57

Trans Tech Publications

Access to resources Recommend Favorite