Study and Build-Up of Deformation Zone at Cutting of Thin-Walled Tube by Torsion

E-ISSN： 1662-9795|2017|746|16-21

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2017, Iss.746, 2017-08, pp. : 16-21

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The Impact of Torsion on the Bending Curve during 3D Bending of Thin-Walled Tubes - A Case Study on Forming Helices

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 1595-1601

Trans Tech Publications

Access to resources Recommend Favorite

Development and Enhancement of Thin-Walled Tube Separation Methods

Key Engineering Materials, Vol. 2016, Iss. 684, 2016-03 ,pp. : 218-221

Trans Tech Publications

Access to resources Recommend Favorite

Analysis of 45 Steel Rectangular Thin-Walled Parts Milling Deformation

Key Engineering Materials, Vol. 2015, Iss. 667, 2016-02 ,pp. : 22-28

Trans Tech Publications

Access to resources Recommend Favorite

Optimization Design of Diamond Circular Saw-Blade with Discontinuous Cutting and Uneven Distribution for Cutting Thin-Walled Tubes

Key Engineering Materials, Vol. 2015, Iss. 667, 2016-02 ,pp. : 114-118

Trans Tech Publications

Access to resources Recommend Favorite

Methods for Analyzing Deformation and Fracture Processes of Thin-Walled Parts from Low-Strength Alloys

By Nikulin S. Khanzhin V. Rozhnov A. Babukin A. Belov V.

Metal Science and Heat Treatment, Vol. 47, Iss. 5-6, 2005-05 ,pp. : 202-209

Springer Publishing Company

Access to resources Recommend Favorite