Investigation of Chip and Surface Roughness when Milling AISI304 Stainless Steel

E-ISSN： 1662-9752|2017|889|152-158

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2017, Iss.889, 2017-04, pp. : 152-158

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Cutting fluid efficiency in end milling of AISI 304 stainless steel

By Abou-El-Hossein K.A.

Industrial Lubrication and Tribology, Vol. 60, Iss. 3, 2008-05 ,pp. : 115-120

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Investigation of properties of ion-nitrided AISI 304 austenitic-stainless steel

By Sahin Mumin Sevil Ceyhun

Industrial Lubrication and Tribology, Vol. 63, Iss. 5, 2011-08 ,pp. : 359-366

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Surface modification of ion-implanted AISI 304 stainless steel after oxidation process: X-ray absorption spectroscopy analysis

By Perez F.J. Gutierrez A. Lopez M.F. Hierro M.P. Pedraza F.

Thin Solid Films, Vol. 415, Iss. 1, 2002-08 ,pp. : 258-265

Elsevier

Access to resources Recommend Favorite

Effect of Variable Pitch on Cutting Temperature, Cutting Forces and Surface Roughness Using Nitico30 Cutting Tool when End Milling of Stainless Steel 316L

Materials Science Forum, Vol. 2017, Iss. 909, 2017-12 ,pp. : 50-55

Trans Tech Publications

Access to resources Recommend Favorite

Ellipsometric characterization of an AISI 304 stainless steel protective coating

By Fuentes-Gallego J.J. Blanco E. Esquivias L.

Thin Solid Films, Vol. 301, Iss. 1, 1997-06 ,pp. : 12-16

Elsevier

Access to resources Recommend Favorite