Study on High-Speed Milling of Steam Turbine Blade Materials - Differences in Cutting Characteristics of an Unforged Ingot and a Forged Part of Stainless Steel

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2017|749|3-8

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2017, Iss.749, 2017-09, pp. : 3-8

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Cutting Force in High-Speed Face Milling AISI H13 Steel

By  

Key Engineering Materials, Vol. 2015, Iss. 667, 2016-02 ,pp. : 35-40

Trans Tech Publications

Access to resources Recommend Favorite

Research on the Influence of Tool Wear on Cutting Performance in High-Speed Milling of Difficult-to-Cut Materials

By  

Key Engineering Materials, Vol. 2016, Iss. 693, 2016-06 ,pp. : 1129-1134

Trans Tech Publications

Access to resources Recommend Favorite

Microstructure and fracture mode of a martensitic stainless steel steam turbine blade characterized via scanning auger microscopy and potentiodynamic polarization

By  

IOP Conference Series: Materials Science and Engineering, Vol. 60, Iss. 1, 2014-06 ,pp. : 26-34

IOP Publishing

Access to resources Recommend Favorite

Analysis of Vibration Amplitude in High-Speed Cutting for Hardened Steel

By  

Key Engineering Materials, Vol. 2015, Iss. 667, 2016-02 ,pp. : 9-14

Trans Tech Publications

Access to resources Recommend Favorite

Heat-Treatment Response and Cutting Properties of Sintered Type M2 High-Speed Steel

By Jagger F. L.   Price W. J. C.   Walker P. I.   Smith P.  

Powder Metallurgy, Vol. 20, Iss. 3, 1977-01 ,pp. : 151-157

Maney Publishing

Access to resources Recommend Favorite