Laser Beam Milling of Alumina Ceramics - The Impact on Material Removal Efficiency and Machined Surface Morphology

E-ISSN： 1662-9779|2017|261|143-150

ISSN： 1012-0394

Source： Solid State Phenomena, Vol.2017, Iss.261, 2017-09, pp. : 143-150

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Material Removal Rate, Kerf, and Surface Roughness of Tungsten Carbide Machined with Wire Electrical Discharge Machining

By Shah Aqueel Mufti Nadeem Rakwal Dinesh Bamberg Eberhard

Journal of Materials Engineering and Performance, Vol. 20, Iss. 1, 2011-02 ,pp. : 71-76

Springer Publishing Company

Access to resources Recommend Favorite

Impact of Milling Intensifiers on Specific Surface Area of Cement

Key Engineering Materials, Vol. 2016, Iss. 722, 2017-02 ,pp. : 140-145

Trans Tech Publications

Access to resources Recommend Favorite

Solidification behavior and microstructural evolution during laser beam—material interaction

By Mohanty P. Mazumder J.

Metallurgical and Materials Transactions B, Vol. 29, Iss. 6, 1998-12 ,pp. : 1269-1279

Springer Publishing Company

Access to resources Recommend Favorite

Joining of alumina ceramics to metals

By Hafez K. M. El-Sayed M. H. Naka M.

Science and Technology of Welding & Joining, Vol. 10, Iss. 2, 2005-04 ,pp. : 125-130

Maney Publishing

Access to resources Recommend Favorite

Effect of cutting parameters on cutting force and surface roughness in milling alumina reinforced Al-6Zn-2Mg-2Cu composites

By Übeyli M Acır A Keleş Ö Akçay C E

Powder Metallurgy, Vol. 54, Iss. 2, 2011-04 ,pp. : 172-176

Maney Publishing

Access to resources Recommend Favorite