Experimental Investigation of Bouncing-Back of Multidirectional CFRP Laminates during Ultrasonic Assisted Edge Trimming

E-ISSN： 1662-9507|2018|382|109-113

ISSN： 1012-0386

Source： Defect and Diffusion Forum, Vol.2018, Iss.382, 2018-02, pp. : 109-113

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Experimental and Numerical Investigation on the Residual Strength of Laminates with Central and Edge Notch

Key Engineering Materials, Vol. 2017, Iss. 729, 2017-03 ,pp. : 128-133

Trans Tech Publications

Access to resources Recommend Favorite

Effects of Tool-Edge Form during the Drilling of CFRP

Key Engineering Materials, Vol. 2017, Iss. 749, 2017-09 ,pp. : 141-147

Trans Tech Publications

Access to resources Recommend Favorite

The titanium image: Bouncing back

By Froes F.

JOM, Vol. 53, Iss. 4, 2001-04 ,pp. : 26-26

Springer Publishing Company

Access to resources Recommend Favorite

Ultrasonic Fatigue of CFRP - Experimental Principle, Damage Analysis and Very High Cycle Fatigue Properties

Key Engineering Materials, Vol. 2017, Iss. 742, 2017-08 ,pp. : 621-628

Trans Tech Publications

Access to resources Recommend Favorite

Shear Cutting Behaviors in Thermosetting and Thermoplatic CFRP Laminates

Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. : 347-352

Trans Tech Publications

Access to resources Recommend Favorite