3D Printing, Ink Casting and Micromachined Lamination (3D PICLμM): A Makerspace Approach to the Fabrication of Biological Microdevices

Author： Kundu Avra Ausaf Tariq Rajaraman Swaminathan

Publisher： MDPI

E-ISSN： 2072-666x|9|2|85-85

ISSN： 2072-666x

Source： Micromachines, Vol.9, Iss.2, 2018-02, pp. : 85-85

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Fabrication of a Lab-on-Chip Device Using Material Extrusion (3D Printing) and Demonstration via Malaria-Ab ELISA

By Bauer Maria Kulinsky Lawrence

Micromachines, Vol. 9, Iss. 1, 2018-01 ,pp. : 27-27

MDPI

Access to resources Recommend Favorite

Highly Fluorinated Methacrylates for Optical 3D Printing of Microfluidic Devices

By Kotz Frederik Risch Patrick Helmer Dorothea Rapp Bastian E.

Micromachines, Vol. 9, Iss. 3, 2018-03 ,pp. : 115-115

MDPI

Access to resources Recommend Favorite

Microfluidics: A New Layer of Control for Extrusion-Based 3D Printing

By Serex Ludovic Bertsch Arnaud Renaud Philippe

Micromachines, Vol. 9, Iss. 2, 2018-02 ,pp. : 86-86

MDPI

Access to resources Recommend Favorite

3D Printing Solutions for Microfluidic Chip-To-World Connections

By van den Driesche Sander Lucklum Frieder Bunge Frank Vellekoop Michael J.

Micromachines, Vol. 9, Iss. 2, 2018-02 ,pp. : 71-71

MDPI

Access to resources Recommend Favorite

Performance Characterization of Micromachined Inductive Suspensions Based on 3D Wire-Bonded Microcoils

By Lu Zhiqiu Poletkin Kirill Wallrabe Ulrike Badilita Vlad

Micromachines, Vol. 5, Iss. 4, 2014-12 ,pp. : 1469-1484

MDPI

Access to resources Recommend Favorite