Process Parameter Control for BEOL TiN Hard Mask Etch-Back

Publisher： Trans Tech Publications

E-ISSN： 1662-9779|2018|282|238-243

ISSN： 1012-0394

Source： Solid State Phenomena, Vol.2018, Iss.282, 2018-10, pp. : 238-243

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Optimization of Wet Strip for Metal Void Reduction in Trench First Metal Hard Mask Back End of Line Process

By  

Solid State Phenomena, Vol. 2018, Iss. 282, 2018-10 ,pp. : 250-255

Trans Tech Publications

Access to resources Recommend Favorite

BEOL Post-Etch Clean Robustness Improvement with Ultra-Diluted Hf for 28nm Node

By  

Solid State Phenomena, Vol. 2018, Iss. 282, 2018-10 ,pp. : 244-249

Trans Tech Publications

Access to resources Recommend Favorite

Effects of Bias Voltage on Microstructure, Hardness and Bonding Strength of TiN Coating Deposited by High Power Pulsed Magnetron Sputtering

By  

Solid State Phenomena, Vol. 2018, Iss. 281, 2018-10 ,pp. : 534-539

Trans Tech Publications

Access to resources Recommend Favorite

Atomic Layer Deposition of TiN below 600 K Using N2H4

By  

Solid State Phenomena, Vol. 2018, Iss. 282, 2018-10 ,pp. : 232-237

Trans Tech Publications

Access to resources Recommend Favorite

Corrosion of Co in BEOL interconnects in dilute HF solution

By  

Solid State Phenomena, Vol. 2018, Iss. 282, 2018-10 ,pp. : 256-262

Trans Tech Publications

Access to resources Recommend Favorite