Precision Control of Kerf in Metal Cutting Using Dry Micro WEDM: Issues and Challenges

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2018|775|499-505

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2018, Iss.775, 2018-09, pp. : 499-505

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Empirical Modeling of Average Cutting Speed during WEDM of Gas Turbine Alloy

By  

MATEC Web of conference, Vol. 221, Iss. issue, 2018-10 ,pp. : 01002-01002

Edp Sciences

Access to resources Recommend Favorite

Synergies in control of the cutting processes

By  

MATEC Web of conference, Vol. 226, Iss. issue, 2018-11 ,pp. : 02009-02009

Edp Sciences

Access to resources Recommend Favorite

Technological possibilities of high-precision plasma cutting in processing materials of different class

By  

MATEC Web of conference, Vol. 224, Iss. issue, 2018-10 ,pp. : 01011-01011

Edp Sciences

Access to resources Recommend Favorite

Multi objective optimization for kerf and material removal rate in wire electrical discharge machining using Taguchi method combined grey relational analysis

By  

MATEC Web of conference, Vol. 204, Iss. issue, 2018-09 ,pp. : 06006-06006

Edp Sciences

Access to resources Recommend Favorite

Modeling and experimental investigation of process parameters in WEDM for surface roughness using regression model

By  

MATEC Web of conference, Vol. 172, Iss. issue, 2018-06 ,pp. : 04010-04010

Edp Sciences

Access to resources Recommend Favorite