Empirical Modeling of Average Cutting Speed during WEDM of Gas Turbine Alloy

E-ISSN： 2261-236x|221|issue|01002-01002

ISSN： 2261-236x

Source： MATEC Web of conference, Vol.221, Iss.issue, 2018-10, pp. : 01002-01002

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Precision Control of Kerf in Metal Cutting Using Dry Micro WEDM: Issues and Challenges

Key Engineering Materials, Vol. 2018, Iss. 775, 2018-09 ,pp. : 499-505

Trans Tech Publications

Access to resources Recommend Favorite

Modeling and experimental investigation of process parameters in WEDM for surface roughness using regression model

MATEC Web of conference, Vol. 172, Iss. issue, 2018-06 ,pp. : 04010-04010

Edp Sciences

Access to resources Recommend Favorite

Modelling and analysis of a high-speed turbine impeller concerning mistuning

MATEC Web of conference, Vol. 211, Iss. issue, 2018-10 ,pp. : 18002-18002

Edp Sciences

Access to resources Recommend Favorite

Performance of LLBC-based rotor blade for low speed wind turbine

MATEC Web of conference, Vol. 197, Iss. issue, 2018-09 ,pp. : 08004-08004

Edp Sciences

Access to resources Recommend Favorite

Increase the Efficiency of a Gas Turbine Unit for Gas Turbine Locomotives by Means of Steam Injection into the Flow Section

MATEC Web of conference, Vol. 220, Iss. issue, 2018-10 ,pp. : 03010-03010

Edp Sciences

Access to resources Recommend Favorite