Sandwich Manufacturing with Foam Core and Aluminum Face Sheets – A New Process without Rolling

E-ISSN： 1662-9752|2018|933|3-10

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2018, Iss.933, 2018-11, pp. : 3-10

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Numerical Simulation on the Compression Property in Different Face Sheet of Sandwich Panel Combined with Aluminum Foam

Materials Science Forum, Vol. 2018, Iss. 933, 2018-11 ,pp. : 351-356

Trans Tech Publications

Access to resources Recommend Favorite

A Novel Method for Preparation of Aluminum Foam Sandwich Panels

Materials Science Forum, Vol. 2018, Iss. 933, 2018-11 ,pp. : 86-91

Trans Tech Publications

Access to resources Recommend Favorite

Modeling and Investigation of the Process of Hot Rolling of Large-Sized Ingots from Aluminum Alloy of the Al-Mg System, Economically Alloyed by Scandium

Materials Science Forum, Vol. 2019, Iss. 943, 2019-02 ,pp. : 58-65

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Deep Rolling Process Parameters on Surface Residual Stress of AA7075-T651 Aluminum Alloy Friction Stir Welded Joint

Materials Science Forum, Vol. 2018, Iss. 939, 2018-12 ,pp. : 23-30

Trans Tech Publications

Access to resources Recommend Favorite

Study on Sandwich Core Modeling for Structural Analysis of Sandwich Composite Structure

Materials Science Forum, Vol. 2018, Iss. 926, 2018-08 ,pp. : 57-63

Trans Tech Publications

Access to resources Recommend Favorite