Impact of Intensification Pressure and Grain Refiner on the Hot Tearing Susceptibility of a Semi-Solid Cast Al-Zn-Mg-Cu Alloy

Publisher： Trans Tech Publications

E-ISSN： 1662-9779|2019|285|283-289

ISSN： 1012-0394

Source： Solid State Phenomena, Vol.2019, Iss.285, 2019-02, pp. : 283-289

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Semi-Solid Slurry Casting Using Gas Induced Semi-Solid Technique to Enhance the Microstructural Characteristics of Al-4.3Cu Alloy

By  

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 253-258

Trans Tech Publications

Access to resources Recommend Favorite

Evolution of Microstructure and Mechanical Properties of Semi-Solid Squeeze Cast A356.2 Aluminum Alloy during Heat Treatment

By  

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 139-145

Trans Tech Publications

Access to resources Recommend Favorite

Microstructure and Properties of Semi-Solid CuSn10P1 Alloy under Different Filling Velocity by Squeeze Casting

By  

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 264-270

Trans Tech Publications

Access to resources Recommend Favorite

Variation of Properties in the Cross-Section of Semi-Solid Al-7Si-0.3Mg Castings

By  

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 81-86

Trans Tech Publications

Access to resources Recommend Favorite

Addition of Swarf to Produce a Semi-Solid Slurry during High Pressure Die-Casting of AS9U3 Aluminum Alloy

By  

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 271-276

Trans Tech Publications

Access to resources Recommend Favorite