Addition of Swarf to Produce a Semi-Solid Slurry during High Pressure Die-Casting of AS9U3 Aluminum Alloy

Publisher： Trans Tech Publications

E-ISSN： 1662-9779|2019|285|271-276

ISSN： 1012-0394

Source： Solid State Phenomena, Vol.2019, Iss.285, 2019-02, pp. : 271-276

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effect of Primary α-Al Morphology in Slurry on Segregation during 357 Semi-Solid Die Casting

By  

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 398-402

Trans Tech Publications

Access to resources Recommend Favorite

Semi-Solid Slurry Casting Using Gas Induced Semi-Solid Technique to Enhance the Microstructural Characteristics of Al-4.3Cu Alloy

By  

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 253-258

Trans Tech Publications

Access to resources Recommend Favorite

Characterization of Microstructure and Shrinkage Porosity of a Semi-Solid Metal Slurry in Gravity Die Casting

By  

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 161-166

Trans Tech Publications

Access to resources Recommend Favorite

Refinement of Primary Silicon Grains in Semi-Solid Al-25%Si Hypereutectic Aluminum Alloy Slurry

By  

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 153-160

Trans Tech Publications

Access to resources Recommend Favorite

Preparation of Semi-Solid A390 Aluminum Alloy Slurry through a Serpentine Pouring Channel

By  

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 169-175

Trans Tech Publications

Access to resources Recommend Favorite