Effect of Primary α-Al Morphology in Slurry on Segregation during 357 Semi-Solid Die Casting

E-ISSN： 1662-9779|2019|285|398-402

ISSN： 1012-0394

Source： Solid State Phenomena, Vol.2019, Iss.285, 2019-02, pp. : 398-402

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Addition of Swarf to Produce a Semi-Solid Slurry during High Pressure Die-Casting of AS9U3 Aluminum Alloy

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 271-276

Trans Tech Publications

Access to resources Recommend Favorite

Semi-Solid Slurry Casting Using Gas Induced Semi-Solid Technique to Enhance the Microstructural Characteristics of Al-4.3Cu Alloy

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 253-258

Trans Tech Publications

Access to resources Recommend Favorite

Characterization of Microstructure and Shrinkage Porosity of a Semi-Solid Metal Slurry in Gravity Die Casting

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 161-166

Trans Tech Publications

Access to resources Recommend Favorite

Refinement of Primary Silicon Grains in Semi-Solid Al-25%Si Hypereutectic Aluminum Alloy Slurry

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 153-160

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Rare Earth Additions on the Microstructure and Mechanical Properties of Al7Si0.3Mg Alloys Processed by Semi-Solid Die Casting and Gravity Die Casting

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 69-74

Trans Tech Publications

Access to resources Recommend Favorite