The Ehrlich–Schwoebel barrier on an oxide surface: a combined Monte-Carlo and in situ scanning tunneling microscopy approach

Publisher： IOP Publishing

E-ISSN： 1361-6528|26|45|455705-455710

ISSN： 0957-4484

Source： Nanotechnology, Vol.26, Iss.45, 2015-11, pp. : 455705-455710

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Cleaved thin-film probes for scanning tunneling microscopy

By Siahaan T   Kurnosikov O   Barcones B   Swagten H J M   Koopmans B  

Nanotechnology, Vol. 27, Iss. 3, 2016-01 ,pp. : 3LT01-8

IOP Publishing

Access to resources Recommend Favorite

Fault detection and isolation in non-linear stochastic systems--A combined adaptive Monte Carlo filtering and likelihood ratio approach

By Li Ping   Kadirkamanathan Visakan  

International Journal of Control, Vol. 77, Iss. 12, 2004-08 ,pp. : 1101-1114

Taylor & Francis Ltd

Access to resources Recommend Favorite

Low-temperature scanning tunneling microscopy and spectroscopy measurements of ultrathin Pb films

By  

Superconductor Science and Technology, Vol. 28, Iss. 4, 2015-04 ,pp. : 45003-45010

IOP Publishing

Access to resources Recommend Favorite

Tip induced mechanical deformation of epitaxial graphene grown on reconstructed 6H–SiC(0001) surface during scanning tunneling and atomic force microscopy studies

By Meza José Antonio Morán   Lubin Christophe   Thoyer François   Cousty Jacques  

Nanotechnology, Vol. 26, Iss. 25, 2015-06 ,pp. : 255704-255710

IOP Publishing

Access to resources Recommend Favorite

Metal surface investigation by scanning probe microscopy

By Thornton J.T.  

Surface Engineering, Vol. 16, Iss. 4, 2000-08 ,pp. : 287-293

Maney Publishing

Access to resources Recommend Favorite